How do l wire them into a three-pin plug? Alternating current switches directions 60 times a second, so you can treat the two wires as identical. Wire them to the left and right plugs. The longer third plug, rotated 90 degrees from the other two, is for ground. You can leave it disconnected for a lamp. Not Helpful 18 Helpful 9.
You shouldn't need to, just buy another plug. Remember to put the proper fuse for the job in it. Not Helpful 6 Helpful 7. Yes, black is the old color for the Neutral terminal, which is on the left. Not Helpful 7 Helpful 9. Include your email address to get a message when this question is answered. By using this service, some information may be shared with YouTube. You will have to take out the fuse to put the wires in place inside the plug. Make sure you put it back in afterwards or the plug won't work as there will not be a complete circuit without the fuse.
Submit a Tip All tip submissions are carefully reviewed before being published. Related wikiHows How to. How to. Co-authors: Updated: September 9, Categories: Electrical Wiring and Safety Switches. Thanks to all authors for creating a page that has been read , times. Did this article help you? Cookies make wikiHow better. By continuing to use our site, you agree to our cookie policy. I gave it a few turns and pulled the wire stripper away from the wire to remove the insulation.
We only want to remove the insulation. If we cut the wires while removing the insulation we should use a larger hole in the wire stripper. The side of the cord with the ridges is connected to the wider prong with the silver screw. The smooth side of the cord is connected to the narrower prong with the gold screw.
Wrap the wire around the screw and tighten the screw. I used a utility knife to cut the broken plug off of the power cord. Next, remove the insulation from the power cord. We need to be careful when making this cut.
If we go too deep we could cut the insulation on the wires. A slice in the insulation of the wires could cause a short which can be dangerous. The plug has a strip gauge which tells us how much of the insulation we need to remove. I used the gauge to mark where to strip the wires.
I gave it a few turns and pulled the wire strippers away from the wire to remove the insulation. The plug has a silver screw, a green screw, and a gold screw. The power cord has a white wire, green wire, and a black wire. The white wire is connected to the silver or light colored screw, the green wire is connected to the green screw and the black wire is connected to the gold or dark colored screw.
After all of the connections were made I gave the wires a gentle tug to be sure they were secure. As part of our commitment to safety, we have launched a Public Awareness Campaign. Learn More. We are committed to educating you and everyone you know about how to stay safe around electricity.
Home Safety. Emergency Contact Contact Us. I Need To. How To Wire A Plug. To correctly wire a plug, follow these guidelines:. Preparing the plug Remove the cover and loosen the screws of the cord grip.
0コメント